Direct Digital Synthesizer Experimenters Kit using an Analogue Devices 14 bit 400MHz AD9954 DDS chip, which is suitable as an accurate signal generator, or as a VFO for a RX or TX project. A bi-directional translator chip is used to interface the DDS chip with the IDC header connector for 5v logic. The various connections on the header allows the board to be used with many micro controller projects found on the WEB, including the Mini-Kits M1-DDS Controller Kit using the M1-DDS software. The DDS output uses a 175MHz 7th order elliptic L.P.F. and GALI-84 amplifier for clean +10dBm output.  For low noise, the PC Board uses plated through holes and separate analogue and digital ground planes, and power supplies.

The Product image shows a fully constructed EME165-R2-54-M Module product.  Please refer to the Options Tab for the descriptions of the various products available.

Please Note: Built products usually need to be constructed and can take up to 2 weeks to ship depending on work load, but are normally shipped in few days.

Basic Kits are only suitable for those that want to use their own Micro-controller and hardware. For a complete Micro-controller solution to use with this DDS board, please see the complete M1-DDS Controller Kit

For the highest performance and reliability, this Kit uses a Genuine Analogue Devices AD9954YSVZ chip and high quality onboard components direct from suppliers in the USA.