The Mini-Kits EME237-70CM is a High Performance RX/TX masthead Pre-amplifier, and is specifically designed for the 70cm 430-450MHz Amateur Band. The design uses the Mini-Circuits PGA-103 E-PHEMT amplifier that has a very high dynamic range and ultra low noise figure, and provides superior performance to Mos or GaAs FETs. The gain is adjustable so that the gain distribution can be optimized for coaxial cable loss that can be significant on the 70cm band, and also to suit the receiver gain.  The design incorporates VOX RF sensed changeover Relays for Trasnsceivers up to 50 Watts CW without using sequencing, or can handle up to 100 Watts PEP if sequencing is used.  An on board bias tee ( DC power injector ), allows the pre-amplifier to be antenna mounted and powered via the coaxial cable. A Tuned input T type filter and low pass filter provides high rejection of signals at 144 and 500MHz.

The Product picture shows a completed EME237-70CM-MH product with TNC connectors. N type connectors or adapters cannot be fitted as they are too large for the enclosure.

Refer to the application block diagram and the EME237 product Webpage for more information.

EME237-70CM-MH Is a fully constructed product in a Nickel sprayed GME masthead enclosure with TNC female connectors.  Please see the specifications TAB for more information.

Enclosure Option ( Preamps ) There is the option to order a built module only without the GME enclosure.

Connector Options ( Preamps ) There is the option for either BNC or TNC type Female connectors. If you are ordering the built module only for your own enclosure, then please use the BNS11-D connectors as these have a panel thread mounting .

N Type Female connectors are not available on this Product due to issues with mounting and RF matching to the PC board

Specifications
Frequency Range:
430 to 450MHz ( BW 20MHz @ 1dB )
Band Rejection:Typically >35dB @ 145MHz, >60dB @ 900MHz
Gain Adjustable:Typically +29dB Max, 20dB Min @ 1290MHz Adjustable
Noise Figure:
1dB ( Typically <0.9dB @ 1290MHz )
Through Loss:
0.7dB @ 435MHz Bypass Mode
RF Power Handling:
50W CW ( Un-Sequenced ) 100W PEP ( Sequenced )
Minimum RF Input:
+20dBm ( 100 mW ) To activate the RF sensing circuit
Operating Voltage:+11 to 15vdc ( +12vdc @ 180mA Recommended )
RF Connectors:TNC Female ( Not available in other types )
Maximum Cable Diameter:6.5mm ( CNT-240® RG-8X Recommended )
Enclosure Size:125mmL x 115mmW x 40mmD
Kit Webpage:For actual product Tests see the EME237 Kit Webpage

This Product is available to ship to Australia and New Zealand Only and is Not available for Export to other countries.

Please Note: Built products need to be constructed and can take up to 10 working days before being shipped.

For more information please see the EME237 Product Webpage

70cm 430-450MHz UHF RX/TX Masthead Preamplifier

  • Brand: Mini-Kits
  • Product Code: EME237-70CM-MH
  • Quantity In Stock: 1
  • $240.00

  • Export: $218.18

Available Options


Related Products

70cm UHF 420-450MHz Receive Only Preamplifier

70cm UHF 420-450MHz Receive Only Preamplifier

Priced from

$26.50 Export: $24.09

CNT®-240 Design Your Own Coaxial Cable Assy

CNT®-240 Design Your Own Coaxial Cable Assy

Priced from

$0.00 Export: $0.00

70CM / 23CM RX/TX Bias Tee

70CM / 23CM RX/TX Bias Tee

Priced from

$57.95 Export: $52.68

70cm UHF Antenna Polarization Switch

70cm UHF Antenna Polarization Switch

Priced from

$40.95 Export: $37.23

70cm 430-450MHz UHF RX/TX Preamplifier Kit

70cm 430-450MHz UHF RX/TX Preamplifier Kit

Priced from

$81.50 Export: $74.09

70cm 430-450MHz UHF RX/TX Preamplifier Diecast Enclosure

70cm 430-450MHz UHF RX/TX Preamplifier Diecast Enclosure

Priced from

$258.35 Export: $234.86